18",18" rectangle created
4' push/pull tool used
Line tool and rectangle tool used to draw the side of the chair in
Push/pull tool used to carve out the top and bottom of the chair
Push/pull tool used to carve the legs of the chair out |
Using infer and push/pull to line up the chair legs
Using the arc tool and push/pull to carve out the top of the back of the chair
Seat of the chair created using rectangle 18",18" and push/pull
Back of the chair created using tape measure 2", line tool, pull up
Tape measure 3" from the top, arc tool and finally push tool to remove the excess
Tape measure 2" on the bottom from each side used, rectangle tool to draw them in
Push/pull to make the legs, infer to line them all up
Measure points deleted, final product
Seat of the chair created using rectangle 18",18" and push/pull
Back of the chair created using tape measure 2", line tool, pull up
Tape measure 3" from the top, arc tool and finally push tool to remove the excess
Tape measure 2" on the bottom from each side used, rectangle tool to draw them in
Push/pull to make the legs, infer to line them all up
Measure points deleted, final product
No comments:
Post a Comment